.

Flexcrete Tiefill

Adam Lowe

Tiefill is a single component, polymer modified, fibre reinforced, Portland cement based repair compound, which exhibits unique hydraulic properties to produce a rapid curing mortar with enhanced polymer properties. The product is supplied as a single component system requiring only the addition of clean water to give a rapid setting, yet durable high strength mortar. It is ideally suited for the filling of voids particularly in new construction which need to be rapidly put into service, such as tie-holes, grout holes and voids around fixings.

Flexcrete Unimatch

Adam Lowe

Unimatch is a single component, structural grade repair mortar, based on the latest polymer cement technology, which is suitable for the repair of damaged, honeycombed or spalled concrete. It is highly waterproof and exhibits good build characteristics. It can be used in vertical, overhead and other difficult areas of repair without the use of primers, special lightweight aggregates or support.

Flexcrete Monorub

Adam Lowe

Monorub is a single component, polymer modified cementitious mortar for the filling of blow-holes and small surface defects in pre-cast and in situ concrete, whilst providing an aesthetic yet durable finish. The incorporation of a polymer enhances adhesion and imparts a high degree of water repellency to the surface of concrete, making it denser and more impermeable. Once cured, it can be readily overcoated with specialist membranes in the Flexcrete range to provide further protection and aesthetic quality.

Flexcrete Monosil

Adam Lowe

Monosil is a surface impregnant, which can be applied to concrete, brick stone etc to impart water and oil repellency. This helps protect the substrate from water and oil ingress and enhances freeze thaw resistance whilst enabling easier removal of oil, grease, paint, graffiti etc. It is particularly suited to the treatment of car park decks and other trafficked areas where oil repellency is required

Flexcrete Polymer Admixture 850

Adam Lowe

Admix850 is ideally suited for the modification of sand and cement to produce hand or spray applied repair mortars and renders with enhanced polymeric and pozzolanic properties. When mixed with cement, the product can be used as a primer for steel reinforcement and a bonding aid for polymer mortars and renders.

Flexcrete Steel Reinforcement Protector 841

Adam Lowe

Steel Reinforcement Protector 841 is for providing a corrosion preventative, flexible coating to steel reinforcement prior to the application of the relevant Flexcrete repair mortars. Forms a highly alkaline coating with a degree of elasticity which not only protects the steel from aggressive acid gases, moisture and chlorides, but passivates the steel surface chemically to prevent further rust formation.

Flexcrete Monolevel FC

Adam Lowe

Monolevel FC is a single component, thixotropic, polymer modified, cementitious mortar with high adhesive properties, allowing it to be used as a thin screed, as well as a filler, for filling minor voids and defects to provide a fair faced finish. It incorporates the most advanced microsilica, fibre and polymer technology, curing to provide enhanced freeze/thaw resistance and protection from the ingress of water, acid gases and chlorides. The product is supplied as a single component system, ready for on-site mixing and use, requiring only the addition of clean water.

Flexcrete Monomix WS

Adam Lowe

Monomix WS is a low density, high strength, shrinkage compensated mortar, which can be applied by wet process spraying techniques for the structural repair, rendering and profiling of vertical, horizontal and overhead surfaces.

1 2 3