Rapid drying industrial topping/wearing surface. Base mix and topping system available. Produces durable wearing surfaces in commercial and industrial areas. This versatile annd user friendly system can be installed from 5mm to 50mm over existing concrete surfaces and can recieve a range of finishes including suitable resin coatings, tiles and natural stone. Rapidry formula.
ARDEX K 301 Exterior Self-Smoothing Levelling and Resurfacing Compound is a special fast setting cement-based product designed to smooth and level rough and damaged concrete surfaces in external and internal situations. ARDEX K 301 is a grey powder consisting of special cements, graded aggregates and high quality synthetic resins. When mixed with water, a fluid mortar is produced which sets within 2 hours and can normally be walked on after approximately 2-3 hours at 20°C. ARDEX K 301 can be applied from 2mm to 20mm in thickness. The set and hardened ARDEX K 301 is usually ready to receive light wheeled traffic after 48 hours at 20°C
The addition of ARDEX E25 Mortar Admix to ARDEX sub-floor smoothing compounds is recommended: where high abrasion or point load resistance is required; where used as a temporary wearing surface; where a floor paint or paint thickness coating is to be subsequently applied as a finish (check compatibility, suitability, and carry out a trial application before proceeding) or where the floor has underfloor heating.
Rapid setting and rapid hardening cement for floor screeds. Walkable after three hours. High strength – 30 N/mm2 after 24 hours – 58 N/mm2 after 28 days. Apply as bonded, unbonded or floating screed. Ceramic floor tiles can be fixed after three hours on bonded screed. Can be pumped – up to 40 minutes workability. Ideal base for in situ floorings, resin toppings, etc., as a bonded screed. Dryshake/sprinkle finish to produce a wearing surface. For internal and external use.
Surface damp proof membrane. Suppresses residual moisture in cement and sand screed and concrete floors. Can accomodate Hygrometer readings up to 98% RH. Guarantees the early laying of all floor coverings. Easy to apply and fast curing. Available in two colours to allow user to visually control coverage uniformity. Provides a bonding agent for Ardex A 35 rapid drying screeds.
Rapid settingn and hardening external repair mortar. For infilling holes around fittings and for patch work on wall and floor areas. Rapid hardening – walkable in 2-3 hours. For repairing stair treads and risers. To produce gradients for ramps. To smooth wall and floor areas from 2 to 30mm thick Easy to smooth and float. Stress and crack free. Wearing surface in lightly trafficked areas. Ideal for patch repairs prior to the application of suitable damp proof membranes.
ARDEX DPM 1C One Coat Damp Proof Membrane and a Residual Moisture Suppressant Features • Suitable for use on surfaces up to 98%RH • Suppresses residual constructional moisture in all concrete slabs and cement/sand screeds • Adheres to damp concrete and cement/sand screeds even at lower temperatures • Apply ARDITEX, ARDITEX NA or ARDITEX RS PLUS to ARDEX DPM 1C without priming • Allows the early laying of all floorcoverings when used with ARDEX smoothing and levelling compounds • Suitable for use on cement/sand screeds containing water based under floor heating systems • Can be used where no damp proof membrane is present or is ineffective
NORTHERN DISTRIBUTION CENTRE
MIDLAND DISTRIBUTION CENTRE
SOUTHERN DISTRIBUTION CENTRE