[logo_carousel_slider].

Vandex Plug

Adam Lowe

Supplied as a powder, Vandex Plug is mixed with water to form a thick paste. Once mixed, the paste is pressed into the leaking crack or hole using a trowel. After approximately 30 seconds, the Vandex Plug will have set and the leak will be sealed. The surface can then be levelled off using a levelling trowel. Vandex Plug can be used internally or externally as a waterproof plugging mortar or where rapid setting and early strength gain is required.

Vandex Super

Adam Lowe

Vandex Super is a cement-based waterproofing slurry specifically designed for concrete waterproofing applications. It is mixed with water prior to application by brush or spray. When Vandex Super is applied to a concrete surface, the active chemicals combine with the free lime and moisture present in the capilliary tract to form insoluble crystalline complexes. These crystals block the capillaries and minor shrinkage cracks in the concrete to prevent any further water ingress (even under pressure). However the Vandex Super layer will still allow the passage of water vapour through the structure.

Vandex BB75

Adam Lowe

Vandex BB75 is a cementitious waterproofing slurry (tanking slurry) with hydrophobic properties, resistant to water and moisture. Vandex BB75 is applied by trowel or spray to surfaces such as concrete, masonry, and render, which have to be sealed and protected against the influence of water and moisture.

Vandex BB75 E

Adam Lowe

Vandex BB75 E is an elasticised waterproofing slurry formed by mixing Vandex BB75 Grey (dry component) with Vandex PK75 (liquid acrylic polymer). The polymer provides elasticity and enhanced crack-bridging properties to the waterproof coating, which has been tested to 7 bar (70m head of water).