Five Star grout SP is a premixed cementitious grout similar to standard Five Star grout developed for applications where economical grout with good flow and retention of flow and higher strengths are required. It is designed primarily as a flowing grout but can be used at a trowellable consistency.
Sika L2 High Flow is a one part, high flow, rapid strength cementitious grout.For precision, high performance, grouting underneath machine bases, structural steelwork, etc
Conbextra UW is used for free flow or pumped grouting applications underwater or in tidal zones. There will be no significant wash-out of the cement phase. Applications include bridge columns, quay pillars, concrete piling, slipways and dams.
Conbextra HF is used for free flow, non-shrink, cementitious grouting of gap thicknesses 10 to 100 mm. Conbextra HF is supplied as a ready to use dry powder. The addition of a controlled amount of clean water produces a free-flowing grout for gap thicknesses up to 100 mm. In addition the low water requirement ensures high early strength and long-term durability.
Conbextra TS is used to grout gap thicknesses 75-500 mm. Applications include grouting thick section voids beneath baseplates; voids around below-ground tanks; large bolt pockets etc.
Conbextra BB is a ready to use cementitious grout supplied in 25 kg moisture resistant bags. It has been formulated specifically for grouting of bridge bearings and parapet post baseplates. The dry powder is a blend of Portland cements, graded silica sands and additives to which only a controlled amount of clean water is added in situ to produce a highly flowable, non shrink grout.
Conbextra GP is used for general purpose, non-shrink cementitious grouting of gap thicknesses 10 to 75 mm. Recommended applications at flowable consistency include stanchion base plates, bolt pockets and void filling. At trowellable consistency Conbextra GP is recommended for bedding load bearing components.
Conbextra EP is For use in situations where heavy dynamic or mobile loads are encountered, e.g. reciprocating machinery, testing equipment, heavy crane and transporter rails, high speed turbines, centrifuges and drop forges. Also for use in conditions where chemical spillage may be encountered. Typical situations could be met in refineries, electroplating works and chemical plants.
